If you are in business, marketing, or something related, we'd highly recommend you take a look at a project that helps keep these plans free. SocialSav is a free, weekly social media digest that helps busy folks keep up with the craziness that is social media news and stats.
Check Out SocialSav's Free Social Digests
The first step, of course, is to wait for cold enough temps. As a general rule, 27° F (-2.8° C) is when you can start making snow.
Next, using whatever stand system you'd like, setup your snowmaker in the place you like to make snow. Your snow will fall in a pile about 20' (6.0m) long and 8' (2.5m) wide.
If it's electric, plug in your air compressor to power outlet. If it's gas powered, make sure the gas tank is full. Connect your air hose to the compressor and be sure your 1/4" FPT (Female) Quick Connect Body is attached to the end of the hose that will attach to the snowmaker.
If it's electric, plug in your air compressor to power outlet. If it's gas powered, make sure the gas tank is full. Connect one end of a garden hose to your water source and the other end to your pressure washer. Connect one of the pressure washer hose to the pressure washer and make sure the other end has the 1/4" MPT (Male) Quick Connect Plug + 22mm Adapter x 1/4" FPT (Female) assembly connected to the end of the hose that will attach to the snowmaker.
When the valve is perpendicular to the body of the valve (or horizontal), the valve is closed.
Connect the air hose to the snowmaker below the valve.
Turn on the air compressor. You can actually open the regulator all the way up because the snowmaker will naturally regulate the pressure.
Connect the pressure washer hose to the snowmaker above the valve.
First turn on the water spigot where the garden hose is attached. Once water is flowing through the nozzles of your snowmaker, turn on the pressure washer. Turning on your pressure washer without water running through it can damage it.
Now, slowly open the valve until just a tiny bit of water comes down and mixes with the air. A light mist will come out of the bottom nozzle. If there are any large drops "spitting" out with the mist, close the valve a tiny bit until the spitting stops and only mist is coming out.
That's it! If it's cold enough, you should be making snow now. By and large, the biggest issue people have is not waiting for it to be cold enough. If you are just making ice, wait until the temp drops 2° F (1° C) and try again.
Keep a close eye on your snowmaker to be sure that your air compressor and pressure washer is still running and things are going smoothing.
At about 10 minutes into your session, check on the valve to make sure the mist coming from the bottom nozzle is still the way it was when you started. If it isn't, readjust the valve until it is.
Remember, the closed position is when the handle is perpendicular to the valve body.
Turn off your pressure washer and unplug it if it is electric.
Disconnect both sides of the garden hose from the spigot and pressure washer and both sides of the pressure washer hose from the snowmaker and pressure washer.
Open the valve and wait about 10 seconds for the air to blow the water out of your snowmaker.
Clear water from your water lines by reattaching the pressure washer hose to the snowmaker and letting the air push the water out of the hose. Once it's clear, put the other end of the pressure washer hose up to one end of the garden hose and let the air push the water out of that hose as well.
Turn off your air compressor and unplug it if it is electic.
It doesn't need to be your living room, just somewhere warm (above freezing) like a garage, basement, or heated shed.